Hello,

Do you have any clue because it's really annoying

I tried also with N4064 and the problem is the same as N2048P

Before I use NAV to modify the description :

    BDX-SW-S0-2#show running-config interface te1/0/1
    description "IOGS Enseignement B2 SR0.2.1"

    BDX-SW-S0-2#show startup-config | begin 1/0/1
    interface Te1/0/1
    description "IOGS Recherche B2 SR0.2.1"

After I use NAV :

    BDX-SW-S0-2#show running-config interface te1/0/1
    description "IOGS Enseignement B2 SR0.2.1 Test"

    BDX-SW-S0-2#show startup-config | begin 1/0/1
    interface Te1/0/1
    description "IOGS Recherche B2 SR0.2.1"

How can I check something ?

Cordialement,

Ludovic Vinsonnaud - Ingénieur Réseau
basé à Bordeaux, bureau F108 (IOA, Rue François Mitterrand, 33400 Talence)

Institut Optique Graduate School
2 Avenue Augustin Fresnel - 91127 PALAISEAU Cedex
Tel. +33 5 57 01 71 52 - Mob. +33 6 08 08 41 05

Le 29/01/2019 à 18:17, Vinsonnaud Ludovic a écrit :

Hello,

When I use portadmin on a Dell N2048P, I change a port description for example and I clic on save.
It say ok for change and ok for save very quickly.
If I connect on the switch, the change is ok in the running-config, but when I check the startup-config, the change isn't done. I wait a few minutes and still no change.

It is working well on Cisco 2960 and 3750 (despite sometimes it's slow if the stack is 8 switch)

Can you help me find where is the problem ?

Regards,

--

Cordialement,

Ludovic Vinsonnaud - Ingénieur Réseau
basé à Bordeaux, bureau F108 (IOA, Rue François Mitterrand, 33400 Talence)

Institut Optique Graduate School
2 Avenue Augustin Fresnel - 91127 PALAISEAU Cedex
Tel. +33 5 57 01 71 52 - Mob. +33 6 08 08 41 05