Try to run the following command:

Switch(config)#snmp-server chassis-id XXXXXXXXX

where XXXXXXXXXX is the "System serial number:" for the switch which you obtain with sh ver.

You must manually add this value to all switches in Cat 2900-series.

Regards Ketil

Asbj?rn Pr?is said:

Hello. On NAV3 rc2 I get this error when trying to add a new catalyst 2924XLv IP device (category SW) :

--- snip --- Add IP device Error: pysnmp.asn1.error.ValueConstraintError: Single value constraint for Version: 0 not within allowed values --- /snip ---

If I reload the page, go back and try again, og just hit continue it disappears!

Anyone else get this, or is it just me?

-Asbj?rn-

---

Nav-users mailing list Nav-users@itea.ntnu.no http://mailman.itea.ntnu.no/mailman/listinfo/nav-users