In NAV2 I used the "Rapportgenerator" (Report generator) to get a listing of the software versions that was on my routers and switches. It was only the Cisco 1900 series switches that did not get listed with a software version number in NAV2. I also missed the sw version number data for AP's, but it seemed like there were no support for that in NAV2. This report was very valuable since I could get a listing of which boxes needed to be upgraded if there were reported some security advisory for a specific software version. But in NAV3 most of my switches is listed without software version. It is only some of the included types that lists up version numbers. This is the wsc5000, wsc5505 and the catalyst297024TS. One type that is included, cat4506, does not report the sw version (but that one also has a supervisor 5 card, not a "sup4" that is in the description). But I have many types of 2950, a 2912 and a 4510r that does not list the sw version. The "Wireless" report in NAV3 have a coloumn for Software but all my C1100's and C1200's and two Avaya ROR-II AP's does not report software version either. Is this a known problem? - Roger -- Roger Aas Stord/Haugesund College