On Sat, 23 Jul 2005, Forselv Ketil wrote:
Try to run the following command:
Switch(config)#snmp-server chassis-id XXXXXXXXX
where XXXXXXXXXX is the "System serial number:" for the switch which you obtain with sh ver.
You must manually add this value to all switches in Cat 2900-series.
Regards Ketil
Asbj?rn Pr?is said:
Hello. On NAV3 rc2 I get this error when trying to add a new catalyst 2924XLv IP device (category SW) :
--- snip --- Add IP device Error: pysnmp.asn1.error.ValueConstraintError: Single value constraint for Version: 0 not within allowed values --- /snip ---
If I reload the page, go back and try again, og just hit continue it disappears!
Anyone else get this, or is it just me?
-Asbj?rn-
Nav-users mailing list Nav-users@itea.ntnu.no http://mailman.itea.ntnu.no/mailman/listinfo/nav-users
Hello Ketil. snmp-server chassis-id is set, so I don't think that is what causing this error message..
-Asbj?rn-