On 02. juni 2017 17:58, Vinsonnaud Ludovic wrote:
Hello,
Hi!
Sorry about my english, I'm french so everything may not be understood :-)
I'm new to NAV and this software seems very interesting for my needs.
Thats good to hear =)
For Dell N2048, I'm a bit confused because if I have this command "switchport access vlan 524" already set in the switch and I ask to change the vlan from 524 to 525 with NAV, it adds this command "switchport general pvid 525" but doesn't delete the old one. So why change a "switchport access" by a "switchport general" ? Is it better to have a "switchport mode general" in default config ? Switchport mode access is the default mode, the 2 combined commands will not work as intended I think ?
We are unfamiliar with Dell switches - PortAdmin has been used extensively with Cisco and HP but I don't know about Dell.
However, we use standard MIBs for all equipment except Cisco.
So, what PortAdmin does when changing vlan is to alter the dot1qPvid-value which is located in the Q-BRIDGE-MIB.
http://www.mibdepot.com/cgi-bin/getmib3.cgi?win=mib_a&r=alcatel&f=IE...
It seems Dell has another way of doing it that does not conform exactly to the Q-BRIDGE-MIB. If you have the MIB for the switch, then we could take a look at it and see if there is anything we can do.
I've not yet tested S4048 and N4064.
--
Regards, IOGS Logo https://www.institutoptique.fr *Ludovic Vinsonnaud * - Ingénieur Réseau basé à Bordeaux, bureau F108 (IOA, Rue François Mitterrand, 33400 Talence)
*Institut Optique Graduate School* 2 Avenue Augustin Fresnel - 91127 PALAISEAU Cedex Tel. +33 5 57 01 71 52 - Mob. +33 6 08 08 41 05