Inside NAV all ports are show as vlan 1 instead of vlan 2, as you can see below from a snippet of configuration. However inside nav gi10 is correctly show as trunk
! interface GigabitEthernet1 switchport access vlan 2 ! interface GigabitEthernet2 switchport access vlan 2 ! interface GigabitEthernet3 switchport access vlan 2 ! interface GigabitEthernet4 switchport access vlan 2 ! interface GigabitEthernet5 switchport access vlan 2 ! interface GigabitEthernet6 switchport access vlan 2 ! interface GigabitEthernet7 switchport access vlan 2 ! interface GigabitEthernet8 switchport access vlan 2 ! interface GigabitEthernet9 switchport access vlan 2 ! interface GigabitEthernet10 description "f-s74 uplink" switchport mode trunk ! exit
-----Messaggio originale----- Da: SRS0=TzH7=4T=sikt.no=morten.brekkevold@srs.uninett.no SRS0=TzH7=4T=sikt.no=morten.brekkevold@srs.uninett.no Per conto di Morten Brekkevold Inviato: mercoledì 21 dicembre 2022 16:30 A: Davide Miccone davide@wpweb.com Cc: nav-users@lister.sikt.no Oggetto: Re: R: [Nav-users] Business 350-8T-E-2G support in NAV versione 5.4.0
On Tue, 20 Dec 2022 13:00:05 +0000 Davide Miccone davide@wpweb.com wrote:
Regarding LLDP , I was wrong, after a while neighbors are show.
Ok, good :) Please beware that while data collection for topology information runs as often as every 15 minutes, topology analysis based on this data only runs about every 30 minutes (as a cron job).
Instead, regarding VLAN, I post below the DEBUG out:
You complaint was that NAV didn't find VLANs (or the incorrect ones). This shows that it found VLAN 1 and 2 on this device. What does NAV show you, and what did you expect it to show?
-- Sincerely, Morten Brekkevold
Sikt – Norwegian Agency for Shared Services in Education and Research