I think I found the solution http://cric.grenoble.cnrs.fr/Administrateurs/Outils/MIBS/?oid=1.3.6.1.4.1.67...
Cordialement, IOGS Logo https://www.institutoptique.fr *Ludovic Vinsonnaud * - Ingénieur Réseau basé à Bordeaux, bureau F108 (IOA, Rue François Mitterrand, 33400 Talence)
*Institut Optique Graduate School* 2 Avenue Augustin Fresnel - 91127 PALAISEAU Cedex Tel. +33 5 57 01 71 52 - Mob. +33 6 08 08 41 05
Le 05/02/2019 à 15:05, Vinsonnaud Ludovic a écrit :
The MIBs are included with firmware updates. Here's for examples the ones for N2000 v6.3.3.14 I begin searching to find something
Cordialement, IOGS Logo https://www.institutoptique.fr *Ludovic Vinsonnaud * - Ingénieur Réseau basé à Bordeaux, bureau F108 (IOA, Rue François Mitterrand, 33400 Talence)
*Institut Optique Graduate School* 2 Avenue Augustin Fresnel - 91127 PALAISEAU Cedex Tel. +33 5 57 01 71 52 - Mob. +33 6 08 08 41 05
Le 05/02/2019 à 13:08, Morten Brekkevold a écrit :
On Tue, 29 Jan 2019 18:17:57 +0100 Vinsonnaud Ludovicludovic.vinsonnaud@institutoptique.fr wrote:
If I connect on the switch, the change is ok in the running-config, but when I check the startup-config, the change isn't done. I wait a few minutes and still no change.
It is working well on Cisco 2960 and 3750 (despite sometimes it's slow if the stack is 8 switch)
Can you help me find where is the problem ?
I can make a very quick assumption:
Dell likely requires an explicit command to store the running-config to the startup-config. The only other platform we've encountered that requires this is is Cisco, and since Cisco supports initiating a "write mem" operation from an SNMP write command, PortAdmin supports it explicitly.
We have no Dell equipment to test on, but if you can dig up some documentation on how to issue a similar command using SNMP on a Dell switch, we should be able to patch NAV.